Monday 2 January 2017

Tiger Winter Maintenance Notes


These are winter maintenance notes for me, but others might find them handy...

Rims:   Front: 36 spoke alloy rim 19 x 2.5"  Rear: 40 spoke alloy rim 17 x 4.25"
2005 Tiger:  14 spoke cast alloy: same size (is this findable?  Yes it is!  Not rears though)

Tires: Front: 110/80-19 Rear: 150/70-17

Coolant flush.  2.8l of coolant (50% distilled water 50% corrosion inhibited ethylene glycol)
- cool engine
- remove fuel tank
- remove pressure cap- 
- unscrew bleed hole bolt (thermostat housing)
- remove reservoir cap
- container under engine
- unscrew drain plug (left side of engine) & drain (keep the old washer for flushing)
- remove lower coolant hose and drain
- flush with tap water
- reinstall old washer & plug & lower coolant hose and fill with water & aluminum friendly rad flush
- reinstall drain plug (25Nm) rad cap and bleed hole bolt (7Nm)
- put fuel tank back on
- run engine to warm (10 mins) then let cool
- re-drain
- refill with plain water, repeat running, cool and redrain
- use a new drain plug washer and torque to 25Nm
- with everything but the bleed bolt installed slowly fill with coolant
- fill reservoir to MAX and cap everything and install bleed bolt (7Nm)
- run 3-4 mins, rev to 4-6k a few times to open it up, check rad and reservoir levels

Spark Plugs:  NGK DPR8EA-9   0.8 to 0.9 gap  20Nm  (under gas tank, like everything else)

Fork oil change:  Kayaba G10 or equivalent 107 mm from top of tube with fork spring removed and leg fully compressed.  Larger riders (like me!) might want 15 weight oil.
Tiger oil change intervals.  Tiger fork oil.
Fork oil viscosity  -  More Tiger fork oil info.
Capacity: 720cc/ml  oil level: 107mm (from top of tube with spring removed and compressed leg)
Removal of forks (with body work & front wheel removed)
- one at a time and with all gubbins removed from fork
- loosen fork clamp bolts
- loosen top fork bolt while it's still on the bike (hard to do when it's off)
- note alignment of fork before removing it
- loosen lower clamp bolts, it should slide loose out the bottom
top fork bolt:  30Nm
clamp bolts top yoke:  20Nm
Handlebar holder clamp bolts:  26Nm

Brake fluid flush   DOT 4

Chassis lubricant (swing arm, stearing head, levers & pedals): Mobile Grease HP 222 or lithium based multi purpose grease.